Hi Hat Control Jack

[dmitri]

I have the synthex kits 2.5 and the sleeve is OK. I haven't analogue board. The power source pin 3 and hihat controller pin 4

Than tip must go to pin 4 and ring must go to pin 3.

[EricSinger]

I have 3 in ring and 4 in tip, with a 4,4K resistor between tip and gnd. and the pedal doesn't nothing if the switch is in roland position, if the pedal is in yamaha position is upside-down hihat controller

[dmitri]

I have 3 in ring and 4 in tip, with a 4,4K resistor between tip and gnd. and the pedal doesn't nothing if the switch is in roland position, if the pedal is in yamaha position is upside-down hihat controller

Not between tip and ground!!! Between tip and ring, i.e. between tip and power source.

[dmitri]

In this case follow Synthex's advice and put 5k-25k (you can try your 4k4 resistor) between tip and sleeve of the HiHat pedal controller input.

My mistake here. It should read "between tip and ring".

[EricSinger]

thanks, i will try now

[EricSinger]

I put the resistor between tip and ring and the V in tip fully open is 4,60V the hats is open, but when I press down the pedal the hats stay in open, and the V is 4,03V, should I change the resistor???

[Synthex]

The pedal is in yamaha position ?

[EricSinger]

No, Roland Position

In yamaha position
FO 4,46V
4,82V
4,77V
FC 0,63V

[dmitri]

Disconnect the pedal and measure resistance in Roland and Yamaha mode in all positions:
1. Tip-Sleeve
2. Tip-Ring

[EricSinger]

Yamaha TIP-SLEEVE

FO-infinite or more than 2M
207k
57k3
9k8
FC-37,3 ohms

Yamaha TIP-RING

FO-infinite or more than 2M
149k
42,5ohm
40ohm
FC-39,5ohm