www.megadrum.info

Hi,

updated my megadrum32 atmega1024 to latest Firmware. rebooted megadrum, set alternate Encoders to true and my Inputs to 22 like before... then i tried to load my to Slot1 saved Settings and f... seems like megadrum go crazy.... many Inputs are triggering, all Settings are set to really crazy results... ex: latency 136 note off 500 and so on...

all my Settings are gone... whats that? remember, had it the first time, the update before this one...

Sounds strange - Firmware version?

Talrusher - You are skilled...but dare I ask you if you did a backup in MDM of all the MD settings first, before upgrading. A firmware upgrade wipes everything in the MD. (To my knowledge)

I am using a ARM based MegaDRUM-32 with 2013-06-12 firmware. I have not had the chance to upgrade to 2013-09-01 yet.

Angr77

You shouldn't load settings in a newer firmware version saved with an older firmware version in EEPROM - unexpected behavior is very likely. Use MDM to save settings between upgrades.

...sh** ... ^^

have allway made updates without saving anything... and allways it goes right. okay. for future updates i would remember your words.

thx

bye ;D