Which input is the first trigger on the lcd levels?

Posted:
Fri Mar 20, 2009 6:53 am
by jeffbeckib
My LCD is suddenly displaying full bars for the first meter. This has happened once before and turning the MD off for a few minutes made it go away, but now it's always showing constant level for the 1st trigger level, it is not showing anything for the corresponding rim level below it, just the top left meter. Which input is that assigned to? I've searched the Forum and can't find anything. I want to start by checking my inputs cable, since I'm only using 4 inputs perhaps one of the other wires on the ribbon that are just folded back are shorting out, but I don't know which of the pins on the input connector would go to the trigger that would come up on that 1st column on the LCD.
Re: Which input is the first trigger on the lcd levels?

Posted:
Fri Mar 20, 2009 8:46 am
by popesky
First upper is Hi-Hat pedal position
Re: Which input is the first trigger on the lcd levels?

Posted:
Fri Mar 20, 2009 3:28 pm
by jeffbeckib
popesky wrote:First upper is Hi-Hat pedal position
Ahh, thank you, so it's not even a trigger, it's more or less the position of CC which isn't even connected yet, so I guess I shouldn't be concerned with this until I finally do connect the controller jack and connect it to a HH pedal
Re: Which input is the first trigger on the lcd levels?

Posted:
Sat Mar 21, 2009 10:22 am
by Ken Forgettable
jeffbeckib wrote:Which input is that assigned to? I've searched the Forum and can't find anything.
Don't forget that for the most part - the main pages are the definitive source of info:
https://www.megadrum.info/~megadrum/?q= ... adrum-menu