Hi Hat Control Jack

[EricSinger]

I'm soldering the 40 pin connector and i don't know which is power source and hihat controller input. The power source is tip or ring? thanks

My hihat pedal is a millenium pedal and only has two states, open or closed. is compatible with megadrum? thanks

Synthex the new atmega works OK

[Synthex]

I'm soldering the 40 pin connector and i don't know which is power source and hihat controller input. The power source is tip or ring? thanks
My hihat pedal is a millenium pedal and only has two states, open or closed. is compatible with megadrum? thanks

On 32 INPUTS Connector :
pin 3 = Power source for HiHat controller
pin 4 = Input for HiHat controller

I do not know how is cabled the millenium pedal ...
Why not to make your own with a pot, to have a proportional command ?

Synthex the new atmega works OK

Great !

[EricSinger]

the millenium pedal is mono. have a switch for roland or yamaha modules, because work different.

I soldered the power in ring the ground in sleeve and the input in the tip, is correctly??

The pedal don't work anyway

I don't make a new pedal whit pot because i think to buy a roland VH11 for my drumset in a month or two month.

[Synthex]

I soldered the power in ring the ground in sleeve and the input in the tip, is correctly ?

Again, I do not know how is cabled the millenium pedal ...
Can you test the pedal with a multi-meter, to know more about it?

[EricSinger]

When the pedal is open there are infinite resistance between tip and ground

when the pedal is close there are about 25 ohms between tip and sleeve

it is all!

a question

because the backlight of my lcd don't work?? my lcd have backlight!!

[mrsamurai]

Not trying to hijack the thread, but I figure posting here would be better than making a new thread.

Is it possible to get firmware that would only have extra inputs, and not have hi-hat controller portion, or are there physical components on the board that are specifically for the hi-hat? I'm asking because I'm going to be making a megadrum to expand the number of inputs I have for my TD-12. It's not a huge deal if it can't be done, but I was just curious.

[Synthex]

Not trying to hijack the thread, but I figure posting here would be better than making a new thread.

Is it possible to get firmware that would only have extra inputs, and not have hi-hat controller portion, or are there physical components on the board that are specifically for the hi-hat? I'm asking because I'm going to be making a megadrum to expand the number of inputs I have for my TD-12. It's not a huge deal if it can't be done, but I was just curious.

There is a physical component on the board that is specifically for the hi-hat controller : a resistor !
All others inputs can be used as extra inputs.

[EricSinger]

Why my pedal doesn't work with megadrum?? Can I use other input to control hats??
Can I have 2 control HH??

If I will do a DIY pot pedal, what components I need?? and the schematic? i read about low impedance and high impedance pedals, there are a problem with this in a DIY pot pedal??

[Synthex]

Why my pedal doesn't work with megadrum??

Did you set the HiHat Pedal as a "F.Contr" ?

Can I use other input to control hats??

No.

Can I have 2 control HH??

No.

[EricSinger]

yes, i config the pedal input as footswitch controller

If I will do a DIY pot pedal, what components I need?? and the schematic? i read about low impedance and high impedance pedals, there are a problem with this in a DIY pot pedal??