Page 1 of 1

Question about Synthex kit

PostPosted: Tue Sep 14, 2010 5:35 am
by educr0w
Hello, I'm building Synthex kit.
Now I'm building 32 inputs board.
I was soldering when I decide to test continuity between pins.
I put the multimeter in continuity (beep mode) and I started with aux7 / aux6 pins
and check them with others pins.

The arrow represents the red cable of the multimeter and the dot represent the other
pin(were I put black cable) that make sound with the multimeter.

Image

There are a lot of connected pins, is that ok??
I'm afraid I make a mistake soldering.

I will appreciate any help with this.

Thanks!
Eduardo.-

Re: Question about Synthex kit

PostPosted: Tue Sep 14, 2010 4:16 pm
by Synthex
All is right :)
They are switched jacks.
With no plug into the jack, all inputs are switched to ground.