This is a new test version:
megadrum_test2.zip
This version does actually send CC data.
Again, set all configurations as you normally do. Very important that you set HighLevel for SnareH to a proper value for your snare mesh pad. MinScan for SnareH should be around 50 (default in this firmware).
When you hit your snare pad, you'll see 4 numbers on the LCD:
1) Top left - raw value.
2) Top right - value adjusted for low hit levels (for hit levels below ~5% of the maximum, otherwise equals to raw value). See 'SanareVar Centr/Rim' below.
3) Bottom left - raw hit levels without 'Curve' adjustment
4) Bottom right - data sent in CC messages. 0 - for centre, 127 - close to rim)
In the menu you will see 3 new parameters:
1) 'SnareVar CC' - MIDI CC message number. Default 16
2) 'SnareVar Centr' - adjusted values higher than set here will produce CC messages with data 0.
3) 'SnareVar Rim' - adjusted values lower than set here will produce CC messages with data 127.
Don't set 'QuickAccess' to yes in this version.
I've also modified Dinamic Threshold algorithm in this version and in my tests rejection of false triggering is much better. I'd like to here feedback on this as well.
You do not have the required permissions to view the files attached to this post.